![]() ![]() If you have upgraded to 2.0.9, please be aware that this release will not work at all with it. Please note that this firmware requires Canon firmware 2.0.8 ONLY. If you are interested in building your own version, you can download sources under the terms of the GPL. If you have any problems, please report them on the issue tracker. Once we have it a stable we should make this one generallyĪvailable since all the new cameras have 2.0.8 pre-installed.įYI: if you have a camera with a serial console, there does appear ![]() Please give it a go and let me know if there are any outstanding Memory it seems to never get the bad results from the read. I also fixed (?) aīug in the bmp_load() code: by reading into an uncacheable region of Writing, zebras, int/ext mic switching, etc). Tests and the few things I tried seemed to work (autoboot, MBR The afternon locating the necessary symbols (thanks, patchdiff2!)Īnd have built a version that boots on the 5D Mark II with 2.0.8.Īttached is a version for folks to test. I have been neglectful of my favorite camera these past few monthsĪnd left it running the older 2.0.4 Canon firmware. You must reload the firmware after every powersave event or card removal.Click the joystick to select items to toggle them.Use the joystick to move between items.Press Picture Style button once LiveView is displayed to bring up the Magic Lantern menu.Camera reboots directly into LiveView mode.Select "Updated firmware" from the menu.Copy the magiclantern.fir and magiclantern.cfg file to the root directory on the CF card.Sometimes the tasks are not properly shutdown when it enters power save mode, leading to the CPU to stay in a tight loop and run down your battery. Very important: remove the battery after each test run.It has proven fairly stable in use, but there are still some rough edges. Lo, and behold, after carefully scanning the menus 3 or 4 times, I dont see any reference to 'Shutter Count. IF IT BREAKS, YOU GET TO KEEP BOTH PIECES.īe careful using this for production work: Please test your camera and the firmware extensively before committing to using it on a set or any "one-take only" events. landscaper1 wrote: I downloaded Magic Lantern because I needed a means of checking shutter count on my two 6Ds, as well as other probable uses. THIS IS DANGEROUS AND MIGHT DAMAGE YOUR CAMERA. Please consider donating to EFF for us, because they do a great job in defending your digital rights, including the right to run third party software on your own devices! ![]() Thanks to your help, we have covered all our funding needs for now. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |